Check Point Software Technologies Smart-1 150 Service Manual download pdf (Page 37)

Customer Replaceable Parts

Smart-1 Hardware Page 37

5. Make sure that the additional hard drives have been inserted correctly and are recognized by the system

by running the command

/sbin/raidconfig status

6. Stop all Check Point processes by running cpstop or mdsstop

7. Stop all other processes that are using /var/log. To see a list of these processes, run lsof

/var/log

8. Add the additional storage to the file system by running the command

/sbin/raidconfig extendstorage

In the event that the storage extension process fails:

1. Run the command

/opt/MegaRAID/MegaCli/MegaCli –CfgForeign -Clear -a0

2. Repeat steps 5 to 8 above.

Verifying Hard Drive Extension

1. Run the /sbin/raidconfig status command to view the status of the hard disk drives. Additional

hard disk drives should appear configured in additional four discs’ RAID 10 arrays.

2. Run the lvdisplay /dev/vg_splat/lv_log command. The additional storage should appear

available under this logical volume.

Cooling Fans

The Smart-1 appliance contains three cooling fans. Each cooling fan operates independently of the other(s),

providing redundancy in the event of failure.

This section presents the procedures for removing and installing a fan unit. It is not necessary to power off

the appliance before adding or removing a fan unit.

Removing Fan Units

To remove a fan unit:

1. Loosen the retaining screws in the corners of the fan assembly.

2. Gently pull the fan unit out of the appliance.

Installing Fan Units

To install a fan unit:

1. Insert the fan unit into the appliance. Push firmly until it clicks into place.

2. Tighten the retaining screws in the corners of the fan assembly.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 43 44 45

No comments

Check Point Software Technologies Smart-1 150 Service Manual Page 37